@Chris
Replies (11)
What type of machines are you using for this?
@DobleDude these parts were turned first from cast iron billets in a 12 station cnc lathe. Then the operation shown on the video is done on the smaller of our Haas cnc milling machines
Draft booster motor runs on electricity?
@Chris Does the generator fun off of excess Steam or is it like a Stanley where you have to be moving?
@alsancle stanley has a pressure diaphram that deforms with pressure and closes a valve in the fuel line . With the stanley this device turns the fire of at a set pressure that is lower than the second safety device which is a saftey valve venting to the atmosphere .
Doble control is all electrical . The pumps are actuated by solenoids and the burner is fan driven. All turning on and off based on demand
only when the wheels turn !!!!!!!!!!!!!!!!
Do you think they jumped through a lot of hoops to not have a neutral capable transmission so you could "idle" the engine and run all the accesories?
not sure , I guess he was just adamant it was un necessary
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.